Hardening dust for cyanoacrylate adhesives Bond Enforcing Dust 20 g GSW 2985 Adhesion-enhancing dust
This curing dust for cyanoacrylate adhesives is a special product developed by Green Stuff World to improve the fill and bond strength of cyanoacrylate adhesives in liquid or gel formulations. It is a highly purified powder with a particle size of 45 to 90 microns, which optimizes its hardening effect. How to use Bond Enforcing Dust
You can do the following: Apply CA glue to the desired area where bonding or filling is required.
Sprinkle the product evenly over the CA glue. Ensure full coverage of the adhesive area.
Allow the CA adhesive and hardener mixture to react for approximately 5 minutes. This reaction time may vary depending on the specific adhesive, the amount of adhesive applied and finally the environmental conditions.
After the reaction time, you can remove the excess by gently sanding it. This stage helps to get a smooth and even surface.
Optional: Optionally, you can also apply hardener directly to hard surfaces that need strengthening or filling. Be sure to thoroughly clean the surface before applying the cyanoacrylate hardener. It is important to note that this hardening powder is not soluble in water, which means that it should be stored in a dry environment to maintain its effectiveness. After each use, make sure the container is tightly closed to prevent moisture from entering and damaging the powder. Additionally, it is designed to be non-toxic, but it is always a good idea to be careful with any chemicals or products that come with the glue. Content: 20 gr.
